Products You'll Need
Surface preparation
Clean the surface to remove dirt and dust
Sanding
Wet sand the bumper with g320 until no more gloss.
Prime
Apply Epoxy primer, with each layer 5 mins drying time. After spraying 3 layers, wait for 1-2 hours for touch dry.
Sanding the Primer
After primer has dried, sand the primer with g600 sandpaper.
colour (base coat)
Apply 3 layers of base coat of desired colour with 5 mins waiting time between layers. After 3 layers, wait 1-2 hours for touch dry.
Clear Coat
Spray 3 layers of clearcoat, details of the three layers:
- Spray a thin layer
- Spray a very wet layer until white water adds up
- Wait until the white area disappears, spray a fast wet last layer
Curing
Wait at least 8 hours for full cure
Common mistakes
Spraying too close
Make sure to spray at a distance of 15cm
Painting in humidity
Humidity will affect the drying time and
Wrong waiting time between layers
Waiting too long between layers will cause low adhesion. Not waiting enough time will also cause low adhesion but to the previous surface.
Touching before curing
This wil leave permanent marks on the paint which you will need to redo the job to get rid of it
Before/after image slider
Brake caliper spray painting FAQS
Yes. Brake calipers can be spray-painted if they are mechanically sound, thoroughly cleaned and correctly prepared. Only the exterior caliper housing should be painted. Paint must never reach the brake discs, pads, pistons, seals or other working components.
A typical bumper restoration requires:
- Cleaner and degreaser
- Sandpaper in suitable grades
- Putty filler for deeper scratches
- Epoxy Primer/Plastic Primer
- Colour-matched base coat (eg. Tintatek)
- Clear top coat
The exact products depend on whether the damage is limited to the clear coat, has reached the colour layer or has exposed the bare plastic.
Begin with a suitable medium-grade abrasive (g240/g320) to smooth deeper scratches, then move progressively to finer grades before priming. After the primer has dried, use finer sandpaper (g600) to create a smooth surface for the colour coat. Avoid using very coarse paper unnecessarily, as it can leave deep sanding marks in the plastic.
Yes, particularly where bare plastic or filler is exposed. Bare plastic normally requires a compatible adhesion promoter followed by primer. This helps the paint bond correctly, creates an even surface and reduces the risk of peeling, cracking or an uneven finish.
Use your vehicle’s paint code rather than choosing a colour by eye. Depending on the manufacturer, the code may be found inside a door shut, under the bonnet, in the boot or in the vehicle handbook.
Age, sunlight and previous repairs can make existing paint differ from the original factory colour. Our Tintatek technology allow you to blend and match the colour to your vehicle's current finish, ensuring a perfect match despite any fading or variation.
Yes, if you are using a base-coat colour system. The clear coat provides gloss, depth and protection against weather, UV exposure and everyday wear. Apply it within the recommended recoat window after the colour coat has flashed off. When using the 2K aerosol clear coat, always follow the safety instructions and use the specified respiratory and protective equipment.
brake caliper products
SAMURAI AeroGun Spray Can Trigger Handle for Tintatek Binder & Aerosols
Samurai 2-Part Paint Multi-Purpose Surfacer, Polyurethane (PU), 400ml
SAMURAI 2-Part Polyurethane (PU) Spray Paint Clear Coat
